We work on furnaces, boilers, heat pumps, ductwork, and thermostats. From Lehi down to Payson, we repair, tune, and replace heating systems. Below is what each job involves and how we handle it. If your heat quit tonight, start with the emergency section.
Furnace Repair in Utah County
When the heat quits on a January night, you need it back fast. We also get calls for furnaces that blow cold or short cycle every few minutes. Nine out of ten of those trace to an igniter, a dirty flame sensor, or a tripped limit switch. A failed blower motor or a bad gas valve turns up too.
A Furnace Repair visit starts with a safety check. Then we test ignition and read the stored error codes. We fix it on the spot or quote a replacement. A cracked heat exchanger means the furnace stays off until it is repaired. No shortcuts there. Cold inversion weeks push old units to run nonstop until something gives.
Furnace Installation and Replacement
Past 15 to 20 years, repair bills start stacking up. Rooms that never warm up are another sign. A heating contractor should size the new unit by square footage, window area, and insulation. Not by what was there before.
Furnace Installation covers removing the old unit, checking the gas line and venting, a new flue, and a condensate drain. We pull the permit and handle inspection through your city building department. Many Utah County homes built from the 1970s through the 90s have an oversized furnace and leaky returns. Right-sizing often fixes the cold back bedroom by itself.
Furnace Maintenance and Tune-Ups
Fall, before the first hard freeze, is the right time. We clean the burners, test the flame sensor, check gas pressure, and inspect the heat exchanger. We change the filter, read blower amps, and confirm venting is safe. The CDC's guidance on carbon monoxide safety explains why that last check matters.
A yearly Furnace maintenace visit catches small faults before they become a no-heat call. Valley dust and farm-field grit clog filters fast here. Check yours monthly. A one-inch filter rated for 90 days rarely makes it that far in this air.
Emergency HVAC Service Across Utah County
No heat overnight. A gas smell, water pooling under the furnace, or a dead system in a hard freeze. Those are calls that cannot wait until morning.
Emergency HVAC Services begin with fast triage. We shut off gas or power, make the house safe, then repair. If a part has to be ordered, we show you how to heat safely in the meantime. We run from Spanish Fork out to Lehi, Eagle Mountain, Provo, and Payson. When valley lows drop, frozen pipes follow a dead furnace within hours.
Heat Pump Installation
An all-electric home, a new addition, or a plan to cut gas use all point toward a heat pump. We install ductless mini splits, ducted systems, and dual fuel setups with a gas furnace as backup.
Heat Pump Installation includes the line set, a dedicated electrical circuit, a pad or wall mount, and a measured refrigerant charge. Around here I lean dual fuel. Our cold snaps drop below what a heat pump handles alone, and the furnace picks up the load. Newer Vineyard and Eagle Mountain builds with tight envelopes do very well on them.
Heat Pump Repair
Weak heat. Ice packed on the outdoor unit, a loud outdoor fan, or a system stuck in defrost. We check the reversing valve, defrost board, capacitor, sensors, and refrigerant charge.
Low charge means there is a leak somewhere. We find it instead of topping it off, because a recharge only hides the problem until the next cold snap. We test the air handler and the backup heat strips too. In winter, Heat Pump Repair here often starts with snow drift and ice built up around the outdoor unit.
Smart Thermostat Installation
Old mercury and dial thermostats still run plenty of furnaces in this valley. If one room bakes while another stays cold, better control helps. We check the wiring first. Many older homes have no C wire to power a smart stat.
Smart Thermostat Installation covers staging, heat pump settings, wifi, and your daily schedule. Placement matters as much as the model. We keep it off sunny walls and away from vents and exterior walls. In two-story Utah County homes where the upstairs runs warm, that one move fixes a lot.
Heating Ductwork Repair and Sealing
Cold rooms, whistling vents, and dust blowing from registers all point at the ducts. We look for leaks, crushed flex duct, boots pulled off a register, and missing insulation. Once we are under the house, a fully disconnected run is a common find.
Heating Ductwork Repair means sealing joints with mastic, reconnecting runs, adding return air, and insulating attic runs. We balance dampers so far rooms finally get airflow. Ducts in unheated crawl spaces and attics bleed heat fast through a valley winter. Any heating contractor can swap a furnace. The ducts decide whether the house feels warm.
Boiler Repair
Cold radiators, baseboard that never warms, a drip underneath, or a boiler that locks out. We check the circulator pump, expansion tank, zone valves, system pressure, and ignition. Then we bleed air from the lines and each zone and test the low water cutoff.
Radiant floor loops and manifolds get checked for flow problems. Hard water in Utah County scales heat exchangers and seizes zone valves over time. On an older system, the valve body is usually the first part to give up. A Boiler Repair call often ends right there.
Boiler Installation and Replacement
A failing boiler, an added zone, or a radiant floor project calls for a new unit. We install high efficiency condensing boilers, combi units that cover heat plus hot water, and standard models. The job includes gas line sizing, venting, near boiler piping, the pump, and the expansion tank.
We pull the permit and schedule inspection through your city office. Older Provo and Spanish Fork homes with cast iron radiators usually keep hydronic heat, and that is the right call. Boiler Installation on those keeps the radiators you already have. Near boiler piping decides how the whole system behaves.